MSDS Headers

[jhora]

Does anyone have any experience with the MSDS brand of headers for the 914-6....Thanks....

[jim dorociak]

They have been around for probably 20+ years. Marty has a twin turbo, flat fan 914-6 that has been written about and lusted over for years. Jim

[gms]

Sounds like a good deal but they don't have any pictures of the 6 headers on the website

[jim dorociak]

I just spoke with Marty at MSDS who has informed me the business started in 1976, so I stand corrected. You can contact him at tech@msdsinc.com and he will send you pictures. Jim
jdorociak@gmail.com

[jhora]

Thanks Glenn and Jim...
I did email Marty and he was kind enough to send me a picture of the 914-6 headers on the weld up jig...this was the only shot he had at the moment...his headers are a little bit different that most as they have longer runners to the flange where all three pipes meet
I was just trying to get a user prospective from someone that had used them......I now have old OEM headers with out the heater boxes and they are getting pin holes in them so need to get some new ones...Marty's Columbus Day deal on his headers is very good and goes to the end of Oct...
Thanks very much for your replies...

[jim dorociak]

Are you staying at the stock size diameter for the headers? I believe it is 1.5" and the next size is 1 5/8" and then up to 1 3/4". I would think these would flow better and many years ago I took my 914/6 headers/heat exchangers and had them ceramic coated and it is the best to keep heat inside the tube and as a protector of the metal exhaust. Jim

[jhora]

Yes I was planning on the 1.5"